Home>Our Products>Personal Protection Equipment>7501 portable eyewasher station
Argentina 7501 portable eyewasher station

Where the eyes of any person may be exposed to injurious or corrosive materials, when suitable facilities for quick flushing of the eyes needs to be provided and a continuous supply of water is not available. Although the 7501 may be installed in a wide variety of locations, it is ideal for the remote and low traffic areas where protective measures are still needed. Emergency eyewash facilities shall be in unobstructed and accessible locations that require no more than 10 seconds for the injured person to reachFor Argentina market.

Popularity: ★★★★ | Add Favorite


This product can be used in field of Petroleum, Chemical, Laboratory, Medical Treatment etc., and flushing the chemistry liquid sputtered eye and face rapidly, so reduce the level of injury to the minimum.
Main Performance:
Material: High density polyester, pro-environment and safety.
Capacity: The maximum reserve is 30L(8 gallon), workable is 20L availably, ensure flushing for 15 minutes.
Water injection hole: wide water injection hole and apt to inject water, have dust cover.
Color: pro-environment green, aesthetic and striking.
Water flow: Due to change diameter on the water hole, so more bonhomie and enrich , water yield is not lower than 1.5L/minute.
Located near happen accident place, see easily and usage conveniently. Can install wall or bracket, or can use with go-cart, mounting height is installation schematic diagram; when open the eye wash arm, the sprayer should be 83.8cm~114.3cm above ground.

  1. After occur accident, must guide injured person to the nearest place of eyewash installation immediately, avoid long time to not wash;
  2. Pull down eye wash arm placidly, so open to spray ;
  3. When wash eyes, open eyes wholly, sufficient wash ,the wash time is not less than 15 minutes ;
  4. After wash, need medical treatment forward.


  1. Portable Eyewash should be check periodically, look at water flow if minify and need water;
  2. Adopt preventive action to prevent water tank’s pollution, as follows: A: add suitable bacteriostat, after evacuate water and wash, then top up purified water, add defined amount bacteriostat; B: if your choice washing fluid is purified water, should replace periodically (change period general is 5~7 days), every month must wash once at least;


  1. The best salve should safety protection preliminary, when you or your colleagues are proceed dangerous goods operation, please wear above equipments to make comprehensive defending: safety goggles, veil, protective gloves, chemical splash suit and so on.
  2. If eyes enter alkalinity or acidity solution, first should use corresponding eyewash ,then wash repetition by eyewash or medical assistance;
  3. On the working environment or environmental hazard, suggest add some measure of appropriative eyewash concentrate, can relief eyes harm, at the same time also lengthen liquid time .
  4. Suggest install indoor ,the environmental temperature is 2ºC ~35ºC .



Trouble shooting:




   Exclude measures


1.No flow.

a.not water
b.water pipe or fitting clogging

1. a. Tank empty.Refill tank.
b.Obstruction in line or fitting.Clear obstruction.


2.Poor flow from eyewash head(s).

a.water few
b.sprayer  clogging

2. a. Tighten head assembly.
b.Check for obstructions. If necessary, remove eyewash head(s), clean and reassemble. To reassemble head, place cap screw through head and thread into head anchor two or three turns. Tilt head assembly and work anchor legs into eyewash armholes. Tighten assembly. Check for leaks.


3.Water leak between joints or fittings.

rubber tube aging

a. Pull hose off fitting. Smooth raised plastic edge on center of fittings. Return hose and hose clamp to original position.

b. Tighten hose clamp(s) with pliers.

Applied industries

argentina petroleum
argentina manufacturing
argentina Lab
argentina Pharmaceutical
argentina Electronic
argentina Food
argentina metallurgy
argentina Miscellaneous